Table 2-5
LOM port description
Chip Model
Port Type
Rate
Negotiation
Mode
Supported
Rate
Rates Not
Supported
X722
10GE optical
port
Auto-
negotiation
10000 Mbit/s
(full duplex)
10000M
10/100/1000M
10GE electrical
port
Auto-
negotiation
1000 Mbit/s
(full duplex)
1000M
10/100M
Auto-
negotiation
10000 Mbit/s
(full duplex)
10000M
10/100M
GE electrical
port
Auto-
negotiation
1000 Mbit/s
(full duplex)
1000M
10/100M
l
Intelligent Computing Compatibility Checker
to obtain information about the
cables and optical modules supported by the LOM ports.
l
The LOM ports support NC-SI, WOL, and PXE.
l
The LOM ports do not support forced rates.
l
The electrical LOM ports cannot be connected to power over Ethernet (PoE) devices
(such as a switch with PoE enabled). Connecting a LOM port to a PoE device may
cause link communication failure or even damage the NIC.
l
The electrical LOM ports do not support SR-IOV.
l
Forcibly powering off a server will cause intermittent NC-SI disconnection and disable
the Wake on LAN (WOL) function of the LOM ports. To restore the NC-SI connection,
refresh the iBMC WebUI.
2.3 Processor
l
The server supports one or two processors.
l
If only one processor is required, install it in socket
CPU1
.
l
The same model of processors must be used in a server.
l
Contact your local Huawei sales representative or use the
to determine the components to be used.
FusionServer Pro 2288H V5 Server
User Guide
2 Hardware Description
Issue 08 (2019-10-30)
Copyright © Huawei Technologies Co., Ltd.
19
