Huawei EGW2100, Web Configuration Manual

Page: 42 / 110

9. Click Add .
10. Enabling RIP on the Specified Network Segment. Set the parameters based on Figure
4-35 .
Figure 4-35 Enabling RIP on the Specified Network Segment
11. Click Add .
12. Click Apply . Then click OK in the Are you sure to submit? dialog box that is displayed
to complete the configuration.
Step 2 Save the configuration.
1.
Click Save on the upper right of the page to save the configuration. Figure 4-36 shows the
parameter setting.
Figure 4-36 Saving the configuration
2. Click OK in the This will save current configuration, if you switch to other pages, you
will not get the operation result. Are you sure to save? dialog box that is displayed to
complete the configuration.
Step 3 Configure Router B and Router C.
For the configuration procedure, see the configurations of the EGW2100.
----End
4.5 Configuration Example of OSPF
OSPF is an internal network gateway protocol based on the link status developed by the IETF
and is also a dynamic routing protocol applied to the internal of the AS.
Networking Requirements
Start OSPF process 100 on the Ethernet0/0/0 interface of the EGW2100 and the interface is in
area 0. Start OSPF process 100 on the Vlanif 5 interface and the interface is in area 1.
4 Configuration Example of the Internetworking
HUAWEI EGW2100
Web Configuration Guide
4-18 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2010-02-20)