3
Requirements for the
Computer
To correctly install and use EC226, the following configurations for the
computer are required.
Item Required
Configuration
USB interface
USB 2.0 Full Speed
CPU
866 MHz Pentium or above
Memory
128 MB or above
Free space on the hard
disk
100 MB or above
Operating system
Windows XP, Windows 2000 or Window
Vista
Screen resolution
1024 × 768 is recommended
Note: Improper configurations may degrade the computer performance. Make sure
that the computer configurations meet the requirements.
For Windows XP, it is recommended to install patches such as Service Pack 2 or
above.
For Windows 2000, it is recommended to install patches such as Service Pack 4
or above.
Getting the EC226 Ready
Note: Make sure whether your EC226 need a UIM card, contact your service provider.
If your EC226 need a UIM card, insert the UIM card into EC226 as follows.
1.
Remove the User Identity Module (UIM) card slot from the EC226. Then
insert the UIM card into the card slot. Make sure that the UIM card is
fully in place.
2.
Insert the card slot into the EC226.
4
Installation Guide
The procedure for installing is subject to the operating system installed on
your computer. The following section takes Windows XP as an example. If
there is any difference, follow the actual installation prompts.
Connecting the EC226 with a Computer
Note: First, power on a computer. Then connect the EC226 with the computer.
Otherwise, the normal installation of the EC226 can be affected.
The following figure is the sketch map of the data cable.
Auxiliary USB data cable
Main USB data cable
Mini-USB Connetor
1.
Plug the mini-universal series bus (USB) connector into the EC226.
2.
Plug the connectors of the main USB data cable and the auxiliary USB
data cable into the USB interfaces of the computer.
