Clip Settings
17
•
DHCP Server
: It is used to assign IP addresses
dynamically. If the DHCP server is
Enabled
, it can
automatically assign IP addresses for PCs. It is
recommended to select
Enabled
for the DHCP server.
•
Start IP Address/End IP Address
: It is used to define
the IP address range that the host can use during the
IP address assignment. For example, in the network
segment 192.168.1.0/24, the default IP address of the
device is 192.168.1.1. The host IP address can range
from 192.168.1.2 to 192.168.1.254. The minimum
range is a single IP address.
•
DHCP Lease Time
: The DHCP server automatically
assigns an IP address to each device connected to the
network. When the leased time expires, the DHCP
server checks whether the device is connected to the
network. If the device is disconnected from the network,
the server assigns the IP address to another device.
Thus, the IP address is not wasted.
Note
• The
Start IP Address
must be smaller than
or equal to the
End IP Address
.
• If the
DHCP Server
is
Enabled
, the
configurations of
Start IP Address
,
End IP
address,
and
DHCP Lease Time
are valid;
otherwise, you cannot configure them.
Clip Settings
1
Click
to access the
Clip Settings
page.
2
Select
Clip Mode
.
3
Click
Apply
.
WLAN Settings
Click
to access the
WLAN Settings
page.
Enabling or Disabling the WLAN
1
Click
to access the
WLAN Enable
page.
2
Select
Enabled/Disabled
to enable or disable
the WLAN.
3
Click
Apply
.
