6
Login Procedure
Step 1
Step 2
Step 3
Turn on the power switch on the external power supply and log in to the
router after the RUN indicator slow blinking green (indicating that the
system is running properly).
Use a console cable to connect a PC to the console interface of the
router.
Start the terminal simulation software, create a connection, specify the
connected port, and set communication parameters as follows:
7 Logging In to the Router for the First Time
Before You Start
If your PC's operating system provides terminal simulation software (like HyperTerminal in Windows 2000), you
do not need to install additional terminal simulation software. If the PC runs on an operating system without
terminal simulation software (like Windows 7), install third-party terminal simulation software on the PC by
referring to user manual or online help.
A PC may have more than one serial port. Select the port connected to the console port. Generally, COM1 is
used. If you modify the serial port communication parameters on the router, modify the communication
parameters on the PC to ensure that they use the same communication parameters, and then set up the
connection again.
If the web page is displayed abnormally, the browser version may be too low. Upgrade the browser and log in
to the web platform using Mozilla Firefox 12.0 or later, Google Chrome 23 or later, or Internet Explorer 8.0 or
later.
The login page varies according to version.
Transmission rate: 9600
Data bit (B): 8
Parity bit: None
Stop bit (S): 1
Flow control mode: None
Step 4
Press
Enter
until a message is displayed asking you to enter the username and password. (The following
information is for reference only.)
Login authentication
Username:admin
Password:
<Huawei>
Info:The entered password is the same as the default. You are advised to
change it to ensure security.
The default user name is
admin
and the default password is
Admin@huawei
.
If you forget the login password, restore the password according to the
Troubleshooting
.
NOTE
After successful login, you can configure the router on the command line interface. For more information, see the
CLI-based Configuration
.
To configure the router using the web-based management system, perform the following steps.
