Installing Cables
●
Connecting the feed line
1. The outdoor AP's antenna ports already have 5 KA surge protection capability. Generally, no surge protection devices
need to be installed; therefore, the antenna cables are directly connected to the AP's antenna ports.
2. If higher surge protection capability is required, the customer can purchase a surge protection device. When installing the
surge protection device, ensure that it is connected to a ground cable.
a
Waterproof adhesive tape
Ground cable
Surge
protection
device
c
b
Waterproof
adhesive
tape
Feed line
Feed line
Connecting the ground
bar
●
Connecting the ground cable
● Cut the cable of proper length, the M4 connector is connected to the AP and the M6 connector is connected to the
ground bar.
7
● When no antenna is installed on the 5G antenna interface, cover the interface with a dustproof cap and wrap the
dustproof cap with insulating tape and waterproof tape.
● Wrap the feed line using one-layer PVC black insulation tape, three-layer waterproof adhesive tape, and then three-layer
PVC black insulation tape.
● Stretch the waterproof adhesive tape evenly and ensure that the upper layer of the tap overlaps 1/2 of the lower layer.
Each layer should be attached tightly.
● Wrap the three-layer waterproof adhesive tape from bottom to up, from up to bottom, and from bottom to up in order.
NOTE