Huawei 5288 V3 V100R003, User Manual

Page: 139 / 297

Step 5 Push the ejector release button on the hard disk. See step (1) in Figure 7-11 .
The ejector lever automatically ejects.
Figure 7-11 Removing a hard disk
Step 6 Hold the ejector lever, and pull out the hard disk for about 3 cm (1.18 in.). See step (2) in
Figure 7-11 . Wait for at least 30 seconds until the hard disk stops working. Then remove the
hard disk from the 5288 V3. See step (3) in Figure 7-11 .
Step 7
Place the removed hard disk in an ESD bag.
Step 8
(Optional) If you do not install a new hard disk immediately, install a filler panel in the slot.
----End
7.6 Installing a Hard Disk
Install a hard disk to replace the original one or add a new hard disk.
You do not need to power off the 5288 V3 before installing a hard disk.
After a failed hard drive is disconnected from the hard drive backplane, wait for 30 seconds
before removing it and inserting a new one. The alarm persists after a new hard drive is
installed and will be cleared after the RAID array is rebuilt. Do not frequently hot-swap a hard
drive to prevent new alarms.
Procedure
Step 1
Wear an ESD wrist strap. For details, see 1 Safety Instructions .
Step 2 Remove the hard disk to be replaced. For details, see 7.5 Removing a Hard Disk .
Step 3
Take the spare hard disk out of its ESD bag.
Step 4 Fully raise the ejector lever and push the hard disk into the chassis along the guide rails until
it does not move. See step (1) in
Figure 7-12 .
5288 V3 Server
User Guide
7 Replacing Parts
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 129