Figure 5-3
SC/PC connector
4.
Remove the optical module and cover the bores with dust plugs. Store optical module
safely.
The latch varies on different optical modules.
shows an optical module with a
clasp latch. To release the clasp latch, rotate it down.
module with a tab latch. The tab latch is released when you pull it.
Figure 5-4
Optical module with a clasp latch
Figure 5-5
Optical module with a tab latch
NOTE
You can use the tweezers (part number: 63120166) to remove an optical module.
5.
Take out the new optical module from the package. Ensure that the optical module is
correctly oriented and gently push it into the optical port until you hear a click.
NOTE
The new optical module must have the same optical parameters as the remote optical module
connected to it.
6.
Identify the optical fibers to be connected to the optical module. Remove the dust caps
from the optical fibers and insert the optical fibers to the bores of the optical module.
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
5 Maintaining the Device
Issue 03 (2019-04-01)
Copyright © Huawei Technologies Co., Ltd.
48
