SPECIFICATIONS
OPERATING INSTRUCTIONS
IMPORTANT POINTS TO REMEMBER
Read
all instructions before use. Save these instructions for later
use.
Follow
all warnings and instructions marked on the product.
Unplug
this product from the power source before cleaning and/or
changing any parts
Do not rest anything on the power cord. Do not place the machine
where the power cord may be stepped on or pulled.
Always
keep out
of reach of
children
and pets.
This sealer should only be in use with an
operator
in attendance.
Before operating, check the heating element, PTFE cover, PTFE
Model
FS-600H
FS-800H
FS-1000H
Power
110V/780W
110V/1050W
110V/1350W
Sealing Length
23.6"
31.5"
39.4"
Seal Type
2.8mm
2.8mm
2.8mm
Heating Time
0.2-3 secs
0.2-3 secs
0.2-3 secs
Weight (lbs)
16
20
20
This sealer should only be in use with an
operator
in attendance.
Never insert
clothing, hands, fingers between the sealing jaws of
sealers.
Never touch
the heating elements with bare hands while the
sealer is plugged into a power source, or in operation, or just
finished operation. It will be
HOT
.
Be sure to
check
for
worn parts
before starting operation.
Do not operate with a
damaged power cord
or plug.
Always keep the unit
clean
. Do not use water. Silicone spray may
be used to clean the unit. Be sure the unit is unplugged from the
power source before cleaning.
When changing
blade
(for sealers with cutters), be
careful
of the
sharp edge.
Before operating, check the heating element, PTFE cover, PTFE
adhesive and sealing pad (silicone rubber).
1.
Set the Power Switch to the
ON
position.
2.
Adjust the timer setting according to the thickness of the
sealing material.
Note: Always start with the lowest
setting and gradually increase to the correct setting.
3.
Pull the film to be sealed in between the base and sealing
jaw.
4.
Place the object to be sealed between the sheets of film.
5.
Press the sealing bar down and seal.
6.
Wait 2-3 seconds to allow the seal to set and lift the
handle.
sharp edge.
When changing the teflon adhesive, be sure the entire surface
under the
heating element
is covered with a teflon adhesive.
Bend down the excess teflon adhesive on both ends. This
prevents the heating element from breaking and the machine from
grounding
.
When replacing the
fuse
, be sure the exact voltage and ampere is
used.
Be sure to keep a record of your model number. Specify this
number when ordering parts.
When replacing any parts, be sure to
mark down
the exact
locations of the connections.
ADDITIONAL INFORMATION
•
Always unplug the unit from the power source before
attempting any maintenance.
•
Always keep the sealing platform clean and remove any
residue found on the platform and Teflon tape. Silicone
spray may be used for this purpose.
•
When replacing the Heating Element, always replace the
PTFE adhesive.
•
Occasionally check the condition of the Silicone Rubber for
wear and burn. A damaged or worn Silicone Rubber will
affect the quality of the seal.
