4.3 Commissioning
4.3.1 Replacement and adjustment of the sealing belt
Remove the safety cover, after the heating block cooling, rotate retaining washer by 90° on both
upper heating block and upper cooling block to lift both two blocks, then loosen the springs on both
embossing roller and pinch roller, meanwhile, remove the guiding belt, so as to make it ready for
removing sealing belts (as below figure).
Move the driven wheel seat (adjusting block) towards heating block, and remove the sealing belt.
Replace it with a new sealing belt and install the guiding belt back.
Adjust the driven wheel, heating blocks, cooling blocks, and pinch roller etc. to the original position.
Connect the power supply to test the machine.
Install the protection cover. When the temperature reaches the setting temperature, the machine is
ready for work.
4.3.2 Forward-and-backward adjustment of conveyor table
Loosen the adjusting knobs on both sides first, and then move the conveyor table forward or backward in
the long slot along the feet. Tighten the knobs on both sides after finishing the adjustment.
16
