Page 9
Setting vertical angle of air flow
While the unit is on, use the
SWING /
DIRECT
button to set the direction
(vertical angle) of airflow.
1. Press the
SWING /DIRECT
button once
to activate the louver. Each time you
press the button, it will adjust the louver
by 6°. Press the button until the direction
you prefer is reached.
2. To make the louver swing up and down
continuously, press and hold the
SWING/DIRECT
button for 3 seconds.
Press it again to stop the automatic
function.
The horizontal angle of the airflow must be set
manually. Grip the deflector rod (See
Fig.2.3
)
and manually adjust it to your preferred
direction.
For some units,
the horizontal angle
of the airflow can be set by remote control.
please refer to the Remote Control Manual.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set
louver at too vertical an angle for long periods
of time. This can cause water to condense on
the louver blade, which will drop on your floor
or furnishings. (See
Fig. 2.2
)
When using COOL or HEAT mode, setting
the louver at too vertical an angle can
reduce the performance of the unit due to
restricted air flow.
Do not move louver by hand. This will cause
the louver to become out of sync. If this
occurs, turn off the unit and unplug it for a
few seconds, then restart the unit. This will
reset the louver
Fig. 2.2
CAUTION
Do not put your fingers in or near the
blower and suction side of the unit. The
high-speed fan inside the unit may cause
injury.
Fig. 2.3
Setting Angle of Air Flow
Setting horizontal angle of air flow
•
Range
Caution: Do not keep louver at too
vertical an angle for long periods of
time. This can cause water
condensation to drip on your
furnishings.
Deflector rod
8
Summary of Contents for HTWS026IX21DPLUS
Page 2: ......
