Function Keys Features
Settings
116
1. Press the Zero Touch key when the IP Phone is idle.
2. Press the OK soft key and the IP Phone will enter the WAN Port interface; you can
change the WAN Type by pressing the Navigation keys.
3. Press the Next soft key to enter Network interface, then you can configure some
information.
4. Press the Next soft key again, you can configure auto provision information.
5. When you finish the setting, you can press the OK to accept the changes.
Note:
This feature is not available on all servers. For more information, contact your
system administrator.
Multicast Paging
You can use multicast paging to quickly and easily forward out time sensitive
announcements to people within the multicast group. You can configure a multicast
paging key or a paging list key on the phone, which allows you to send a Real Time
Transport Protocol (RTP) stream to the pre-configured multicast address(es) without
involving SIP signaling. You can configure the phone to receive an RTP stream from
pre-configured multicast listening address(es) without involving SIP signaling. You can
specify up to 10 multicast listening addresses.
Sending RTP Stream
To configure a multicast paging key via Phone interface
1. Press Menu →Features →line or Line Key →Line Key2
（
e.g.
）
2. Press and or Switch key to select the Multicast Paging in the Type field.
3. Enter the multicast IP address and port number (e.g., 224.5.6.20:2000) in the Value
field.
The valid multicast IP addresses range from 224.0.0.0 to 239.255.255.255.
4. Press or Save soft key to save the configuration
