T2000-T2100
EN – 20
4.8.
MANAGING THE MEMORY
4.8.1. Storage of data in the memory
With a measuring result shown on the display, by shortly pressing the multifunction key “
2
”
(
MEM
function), the instrument automatically saves the result in the instrument’s memory,
starting from location “01” (see Fig. 32)
).
(T2000 only)
Fig. 32: Examples of saving resistance and current measuring results in the memory
If the internal memory of the clamp is full,
by shortly pressing the multifunction key “
2
”
(
MEM
function), the instrument shows the
screen in Fig. 33 for 2 seconds, then goes
back to the previously set real-time
measuring mode (resistance or current).
Fig. 33
4.8.2. Recalling the results stored in the instrument’s memory
1. Press and hold the multifunction key “
1
” for more than 2 seconds to switch on the
instrument
2. Shortly press the multifunction key “
1
” repeatedly until accessing the memory area
(
RECALL
function). The instrument displays the last datum saved in the memory and
symbols
+
(see Fig. 34)
(T2000 only)
Fig. 34: Examples of recalling data in the internal memory on the display
In case there are no data saved in the
internal memory, the instrument shows the
screen in Fig. 35 for a few seconds, then
goes back to resistance measuring mode.
Fig. 35
3. Shortly press the multifunction keys “
2
” ( function), or “
3
” ( function), to respectively
increase or decrease the number of the memory location and display the saved data or
shortly press the multifunction key “
1
” to quit this mode.
