![background image](http://html1.mh-extra.com/html/ht/easytest-combi519/easytest-combi519_user-manual_2178079069.webp)
EASYTEST-COMBI519
EN - 69
6.7.9. Verification of protection against indirect contacts (TT systems)
1. Press the
MENU
key, move the cursor to
LOOP
in the
main menu by means of the arrow keys (
,
) and
confirm with
ENTER
. Subsequently, the instrument
displays a screen similar to the one reported here to the
side.
Select “Europe” as a country (see § 5.1.2), the options
“TT”, “25 or 50V”, “50Hz or 60Hz” and the reference
voltage in the general settings of the instrument (see §
5.1.3).
L O O P
15/10 – 18:04
TT
R
A
Ut
=
=
- - -
- - -
V
FREQ. = 0.00Hz
VL-PE=0V
Ra 2Wire 30mA
FUNC
MODE
I
n
2. Use the
,
keys to select the parameter to be modified, and the
,
keys to modify the
parameter value:
FUNC
the virtual key allows setting the measuring mode of the instrument, which
may be
Ra
MODE
fixed
2-Wire
mode
I
n
The virtual key allows setting the nominal value of the RCD’s tripping current,
which may be:
6mA, 10mA, 30mA, 100mA, 300mA, 500mA, 650mA, 1000mA
Press the
SAVE
key to save the selected parameter and go back to the
measurement screen.
3. If possible, disconnect all loads connected downstream of the point to be measured, as
the impedance of these users could distort the test results. Perform the preliminary
calibration of the test leads as described in § 6.7.2.
4. Insert the green and black connectors of the three-pin plug cable into the
corresponding inputs B3 and B1 of the instrument. As an alternative, use the single
cables and apply the relevant alligator clips to the free ends of the cables. It is also
possible to use the remote switch probe by inserting its multipolar connector into the
input B1. Connect the Mains Plug, the alligator clips or the remote switch probe to the
electrical mains according to Fig. 28, Fig. 29 or Fig. 30.
5. Note the correct voltage values between L-PE as shown
in the screen to the side.
L O O P
15/10 – 18:04
TT
R
A
Ut
=
=
- - -
- - -
V
FREQ. = 50.00Hz
VL-PE=232V
Ra 2Wire 30mA
FUNC
MODE
I
n