HSM HSM1854M, Instruction Manual

Page: 16 / 93

05/2012 SECURIO P 36
15
english
Fault and function indicators
Display Problem Measure
Continu-
ous lamp
Flashing
light
Paper jam
Overload You have fed in too much paper.
The cutting unit runs in reverse for a few seconds and pushes the paper
back out again.
• If necessary, press the reverse button “R” to remove the stack of paper.
• Take half the stack of paper.
• Feed the paper in portions.
Note:
You can lift up the safety element in order to better remove paper. To do
this, press the middle section of the front of the safety element and lift up
the
fl ap.
Note:
This indicator lamp also lights up when the motor is overloaded. In this
case, let the shredder cool down for 20 minutes before using it again.
Paper and
CD fed at
the same
time
• Do not use both cutting units at the same time, but rather shred paper and
CDs/diskettes/credit cards separately.
Press safety
element • The LED also fl ashes if you press the safety element or open the door while
there is a paper jam.
Continu-
ous lamp
Flashing
light
Paper/
shredded
material
container
full • Empty the paper/shredded material container.
Note:
If you press the reverse button brie fl y before opening the door, part of the
material is pulled back into the cutting apparatus.
CD contain-
er full • Empty the CD container. To do so, lift it upwards out of the bracket.
Door is
open or
safety
element not
latched • Close the door or latch in the safety element.
Note:
Movement of the safety element was detected during the shredding proce-
dure. If your machine switches off without signalling an error, pull the paper
out of the paper slit and feed it back in again.
Metal detec-
tion • Press the reverse button and pull the paper put of the feed slot.
• Remove any metal which is in the paper or on the safety element.
• Acknowledge the error by pressing the R button.