HSM 105.2HS-L5, Instruction Manual

Page: 4 / 4

operating instructions operating instructions
5. installation
• This paper shredder should never be placed near or over a radiator or heat
source.
• The ventilation slots must not be blocked or covered and they must be at a
distance of at least 4” away from walls or furniture.
• Make sure the power plug is easily accessible.
• Before plugging in the power plug, check that the voltage and frequency of
your local main supply correspond to those stated on the type plate.
6. putting into ope­ration
switching the­ pape­r shre­dde­r on
• Press rocker switch pos. 1.
• Rocker switch locks in.
• Green LED lights.
• Paper shredder is ready for operation (standby).
Fe­e­d pape­r
See “Technical data” for sheet capacity.
• The shredding process is started by a photo–cell in the paper
feeding opening.
• When the paper feeding opening is free again, the cutting system
automatically switches off after approx. 3 sec. and returns to
standby.
switching pape­r shre­dde­r off
• Tap rocker switch pos. 2.
• Rocker switch resets to zero position.
1
2
• Press and hold down rocker switch pos. 2.
• Paper is pushed out.
• Separate paper stack.
• Press rocker switch pos. 1.
• Feed paper successively.
cut mate­rial containe­r full
• Red LED on control panel lights.
• Paper shredder switches off
Empty the cut material container, because if it is too full,
malfunctions can occur in the cutting system
• Tap rocker switch pos. 2.
• Empty full shredded material container.
shre­dde­d mate­rial containe­r contact inte­rrupte­d
• Red LED on control panel lights.
• Paper shredder switches off.
• Check whether shredded
material container is correctly inserted in bottom frame.
If other faults occur, please check the following before calling our customer
service:
• Is power plug inserted?
• Is rocker switch turned on?
• Is the motor overloaded?
allow motor to cool down for 15 - 20 min.
2
1
2
1
2
7. trouble­shooting
pape­r jam
You have­ fe­d in too much pape­r.
Caution!
Do not press rocker switch alternately forwards/backwards
(pos. 1 / pos. 2):
Cutting unit can be damaged.
8. Mainte­nance­ and care­
cle­aning:
• Switch off the shredder, pull out the power plug.
• When cleaning only use a soft cloth and a mild soap-water solution. Never use
scouring agents, cleaning fluid, petroleum or thinners.
Whe­n the­ cutting capacity drops or the­ noise­ incre­ase­s (cross cut):
• Switch paper shredder off:
Tap rocker switch pos. 2.
• Spray special cutting block oil through paper feed opening across
the whole width of the cutting system blades.
• Run cutting system backwards (pos. 2) without feeding paper.
• Paper dust and particles are shaken off.
2
2