1. INTRODUCTION
1.1. This manual contains information applicable
only to the Reliance® Series 4200 Stools. Should
you have a different model, please disregard any
information that does not apply.
1.2. Whenever you see the symbols shown below,
heed their instructions! Always follow safe operating
and maintenance practices.
“WARNING”-
The warning symbol identifies
special instructions or procedures which,
if not correctly followed, could result in
personal injury.
“VERTISSANT“-
Le symbole d’avertissement
identifie les instructions spéciales ou les
procédures qui, sinon correctement suivi,
pourraient avoir comme conséquence des
blessures.
“CAUTION”-
This caution symbol identifies
special instructions or procedures which, if
not strictly observed, could result in damage
to or destruction of equipment.
“ATTENTION“
- ce symbole d’attention
identifie les instructions spéciales ou les
procédures aux lesquelles, sinon strictement
observés, pourrait avoir comme conséquence
les dommages ou la destruction de
l’équipement.
“NOTE”-
Note indicates points of particular
or additional information.
“NOTE” -
la note indique des remarques
d’information particulière ou supplémentaire.
1.3 Should your product not perform properly, or if
you have any questions concerning the use and care
of any Reliance® product, contact the Reliance®
Distributor where you purchased this product or
contact the Technical Service Department, Reliance®
Medical Products, Inc., 3535 Kings Mills Road,
Mason, Ohio 45040-2303, or call (800) 735-0358.
“NOTE”-
Always have the model number and
serial number available before contacting
Reliance® or your authorized Reliance®
Distributor.
“NOTE”-
Ayez toujours le numéro et le
numéro de série de type disponibles avant
Reliance® entrant en contact ou votre
distributeur autorisé de Reliance®.
2. INSTALLATION
2.1. Unpacking
2.1.1. Open the shipping carton carefully and record
any shipping damage to the carton or to the contents.
2.1.2. Remove all contents from the shipping carton.
Note that Model 4246 stool is shipped with the back
support mounted, but inverted.
2.2. Assembly
2.2.1. lf the Model 4240 was ordered, there is no
assembly required. To assemble Model 4246, loosen
the thumbscrew (ltem 5, Figure 1) and remove the
back support (ltem 3, Figure 1). Re-install the back
support in its correct (upright) position and tighten
the thumbscrew.
2.2.2. Remove the upholstered back assembly (ltem
1 , Figure 1) from the smaller box and remove the
handwheel (ltem 2, Figure 1) and two washers (Item
6, & Item 7, Figure 4). lnsert the stud on the uphol-
stered back through the slot in the back support and
the washers on the same side as the handwheel.
2.2.2.1. Hold the upholstered back in the correct
position and tighten the handwheel.
“NOTE”-
When installing the upholstered back,
make sure the narrow portion of the back is
down, or closest to the upholstered seat.
“NOTE”-
En installant tapissé en arrière,
assurez-vous que la partie étroite du dos est
en baisse, ou le plus proche du siège tapissé.
IN-4200
4
“WARNING” -
Never place a damaged
stool into service. Contact your Reliance®
Distributor.
“AVERTISSANT“ -
Ne placez jamais un
tabouret endommagé en service. Entrez
en contact avec votre distributeur de
Reliance®.
