5.1 Adding Incoming Area Codes or Prefixes to the BLACKLIST
Follow the steps below to add incoming phone area codes and prefixes to BLACKLIST.
Step 1. Press “SET” button (LCD displays SET 1234567)
Step 2. Lift off handset and press 5 (If your BLACKLIST is empty, a blinking cursor should be
shown as "_" indicating input mode. Otherwise, the LCD will display the first stored number in
the BLACKLIST)
Step 3. Input the area code or prefix you wish to block
(2)
(example area code: 305, prefix 305-
558) using the dial-pad on your telephone handset.
Step 4. Press the scroll buttons (
◄
or
►
) to save number
(4)
(LCD
displays "SAVE" and
"SUCCEED"). Repeat steps 2 & 3 to add up to 10 “SET”s (up to 10 digits in length, each)
Step 5. When done, hang up handset, or wait 15 seconds to exit programming mode.
6.0 Turn ON/OFF feature to Block all Incoming Calls with no Caller ID Info
This feature is disabled (OFF) as a factory default setting. Please follow the steps below if you
wish to turn this feature "ON" and block all calls with no caller ID information.
Step 1. Press “SET” button (LCD displays SET 1234567)
Step 2. Lift off the handset and press “6” (LCD displays "OFF")
Step 3. Press the scroll buttons (
◄
or
►
) to toggle feature "ON" and "OFF".
Step 4. When "ON" is shown, hang up handset, or wait 15 seconds to exit.
TIP: We do recommend leaving this feature ON permanently as it may block important calls
from friends and family that show partial or no caller id.
7.0 Changing the Pass Code
The T-Lock Call Blocker's factory default pass code is 0000. Follow steps below to change it:
Step 1. Press “SET” button (LCD displays “SET” 1234567)
Step 2. Lift off the handset and press “7” (LCD display "INPUT-")
Step 3. Input old pass code (default 0000) and press “SET” (LCD displays "N-PASS-")
Step 4. Input the new pass code (up to 4 digits) press “SET” button.
Step 5. Re-enter new pass code and press “SET” to save it
(4)
(LCD displays "SUCCEED").
Step 6. Hang up handset, or wait 15 seconds to allow T-Lock Call Blocker to exit programming
mode.
Note: You may use "8289" if you forget your pass code to reset back to default (0000).
8.0 Browsing Lists
