Call Blocker User Manual
Model CT-CID 803 V5.0
(Applies to OEM brands: T-LOCK Call Blocker V5, PRO Call Blocker N2, PHONE DEFENSE Call Blocker V5)
Congratulations on your purchase! This document provides instructions on how to set up,
install, and program your call blocker model CT-CID803.
Packing content:
(1) Call Blocker device with LCD
display, 6 buttons (SET, OUT,
BLACKLIST, REMOVE, SCROLL (
◄
or
►
) buttons), and two RJ-11
sockets (TO LINE, TO PHONE).
(1)Telephone cord
(1) Wall / Desktop bracket
(1) User manual
Quick Setup:
This device is powered by your phone line. Simply plug-in your Call Blocker to an existing
phone jack (or modem) in series or parallel (as shown below) and wait for calls to start ringing.
Then follow the instructions under the ‘Getting Started’ section below to start building your
BLACKLIST. It’s that simple!
IMPORTANT: Please make sure your phone line has ‘Caller ID service’ active. Your Call Blocker
will not work properly without it. If you are not sure, please contact your telephone service
provider.
TIP 1:
Watch this Quick Set-up Video
TIP 2:
In the rare case that your Call Blocker device is NOT registering incoming
calls, please call us to request an exchange/replacement unit. A similar call
blocker device using a different software (compatible with your service) can be
sent to you at no additional cost if requested within the first 30 days of the
purchase date.
Installation:
There are 2 ways of installing your call blocker as shown below. Your call blocker should work
in both settings. First, you should try the SERIES INSTALLATION. Only if you experience any
