VDPLOW890_v2
HQPOWER
4
•
Use the original packaging if the device is to be transported.
•
All modifications of the device are forbidden for safety reasons.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
a) General
•
The device can be wall or ceiling-mounted.
•
Choose a suitable mounting spot and fix it in the desired angle.
•
Connect the power plug to the mains.
•
Switch off the power by disconnecting the
VDPLOW890
from the mains.
b) Mounting the Device
•
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
•
The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
•
The installation must always be secured with a secondary attachment e.g. a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
•
Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used… Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
•
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
•
Make sure there is no flammable material within a 0.5m radius of the device.
•
Have a qualified electrician carry out the electric connection.
•
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
•
The installation has to be approved by an expert before the device is taken into service.
5. The Menu
See table on the second page.
6. Use
REMARK: When using the device for the first time, leave the LED bar switched on for a period of 3 hours in order to
fully charge the battery.
•
Manual Mode
1
Red dimmer
2
Green dimmer
3
Blue dimmer
Summary of Contents for VDPLOW890
Page 2: ...VDPLOW890_v2 HQPOWER 2...
