VDL20ST
- 3 -
HQPOWER
VDL20ST – STROBOSCOPE – 20 W
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to
a specialized company for recycling. This device should be returned to your distributor or to a local
recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing HQPOWER! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
•
DO NOT OPEN THE HOUSING!
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
•
A qualified technician should install and service this device.
•
Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
•
This device falls under protection class I. It is therefore essential that the device be earthed. Have a qualified
person carry out the electric connection.
•
Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
•
Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
•
Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
•
There may be some smoke or a particular smell when the device is activated for the first time. This is normal and
any smoke or smell will gradually disappear.
•
Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
•
Note that damage caused by user modifications to the device is not covered by the warranty.
•
Keep the device away from children and unauthorised users. Keep the device away from splashing and dripping
liquids. Never put objects filled with liquid on top of the device.
•
Do not operate the VDL20ST without glass pane or with a cracked glass pane. Have it replaced when it is
damaged.
3. General Guidelines
•
The VDL20ST should only be used indoors with an alternating current of max. 230 VAC / 50 Hz.
•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Select a location where the device is protected against extreme heat, dust and moisture. Respect a minimum
distance of 0.5 m between the device’s light output and any illuminated surface.
•
Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
•
Use the original packaging if the device is to be transported.
•
All modifications of the device are forbidden for safety reasons.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Keep this device away from rain and moisture.
