5
O p e r a t i o n a l .
Buttons on the front panel
Switching On and Off:
Connect power to the unit and switch the mains on. Switch
on the unit.
When switching off the unit: switch off the amplifier first.
When switching on the unit: The display shows the welcome
screen. After a short period the display menu shows.
Selecting input:
Push Select or Volume- buttons on the front panel to select
the wanted input. When the input is selected and locked,
the front panel displays input type, which can be either
PCM or DSD. For PCM input the sampling frequency shows
and for DSD input the sampling rate shows.
Altering the Volume Level
The volume can be adjusted by using the front panel
buttons Select, Volume. The front panel displays the volume
level.
Mute On/Off
Push Volume - buttons on the front panel.
Stanby On /Off:
Push Select - buttons on the front panel.
Digital filter selection:
The unit offers a wide choice of filters to enhance your
listening experience. Two digital filter settings are possible,
sharp roll-off and a slow roll-off for PCM mode. For DSD
mode, there are 4 available filters with cut off at 47kHz,
50kHz, 60kHz and 70kHz.
For filter selection use the Remote Control.
Enter the programming mode by Pushing the SET button.
PCM filters:
Select sharp roll-off or slow roll-off by pushing
the buttons V+ or V-.
DSD filters:
Select cut off at 47kHz, 50kHz, 60kHz or 70kHz
by pushing the buttons CH+ or CH- .
Select the desired filter setting and Save the new setting
by pushing the
DSP
button followed by the SET button.
DISPLAY Light:
Phase invert:
Custom default start up setting:
It is possible to change the default start up setting. E.g. if the
optical input is often used, it can be a nice feature to have
the DAC unit start up with the Optical input as default.
By pushing the
DSP
button in the "setting state” the unit will
save the status for next switch-on.
Selecting input:
Push CH+ or CH- buttons on the Remote Control to select
the wanted input.
When the input is selected and locked, the front panel
displays input type, which can be either PCM or DSD. For
PCM input the sampling frequency shows and for DSD input
the sampling rate shows.
Volume Level:
The volume can be adjusted by using the Remote Control
buttons V+ or V-. The front panel displays the volume level.
MUTE:
To mute the analog output, push the Mute button. Push the
Mute again for unmute the analog output. The Front panel
will display the Mute status.
Operational using the Remote Control
SET
PWR
CH+
CH-
MUTE
DSP
V+
V-
volume up
volume down
setup
mute
power on/off
input selection
power on/off
