TP809 Programming Manual
47
9 Line Spacing Commands
ESC 3
[Function]
Set line spacing
[Format]
ASCII
ESC
3
n
Hex
1B
33
n
Decimal
27
51
n
[Range]
0
≤
n
≤
255
[Default]
In case of 203dpi n = 34
In case of 180dpi n = 30
[Description]
Sets the line spacing to n × (vertical or horizontal motion unit).
[Notes]
■
The maximum line spacing is 1016 mm {40 inches}. If the specified amount
exceeds 1016 mm {40 inches}, the line spacing is automatically set to 1016 mm {40
inches}.
■
When standard mode is selected, the vertical motion unit is used.
■
When page mode is selected, the vertical or horizontal motion unit is used for the
print direction set by ESC T.
• When the starting position is set to the upper left or lower right of the print area
using ESC T, the vertical motion unit is used.
• When the starting position is set to the upper right or lower left of the print area
using ESC T, the horizontal motion unit is used.
■
The line spacing can be set independently in standard mode and in page mode.
• In standard mode this command sets the line spacing of standard mode.
• In page mode this command sets the line spacing of page mode.
■
When the motion unit is changed after the line spacing is set, the line spacing
setting does not change.
■
Selected line spacing is effective until ESC 2 is executed, ESC @ is executed, the
printer is reset, or the power is turned off.
Summary of Contents for TP809
Page 1: ...TP809 Programming Manual Rev 1 2...
Page 32: ...TP809 Programming Manual 26...
