7
● Low power alarm: when the battery is low, the power indicator blinks and the buzzer
rings 2 times;
and if the user doesn’t charge, it will intervally beep to inform the user to
charge.
● Battery full charge time: 2 to 4 hours.
● Battery duration: under 15% print density, at least 100 to 200 meters, under 25%
print density, at least 100 meters, the standby time is over 15 days.
Chapter 3 Operation Methods
3.1 Preparation before using
3.1.1 Li-ion battery installation
1) Refer to the picture, put the battery in the battery slot, please pay attention to
the correct positive and negative.
2) Close the battery case.
3.1.2 Paper loading
Operation methods
:
1) Use two fingers to press the place showed in the picture and open the upper cover.
2) Put the paper into the paper case, pay attention to the direction of the paper. If loaded
reversely, it won
’t print.
3) Pull paper out of paper case.
4) Make sure paper in the center then close upper cover.
Use two fingers to
press this place and
open the upper cover.
Upper cover
Platen
