TREADMILL
9
ERROR MESSAGE AND SOLUTION
Problem
Possible cause
Corrective action
Treadmill does not work
a) No connection to power supply
Plug into mains socket
b) Safety key not connected
Connect safety key to control panel
c) Damaged or disconnected cable
Check control panel and signal cable
d) Treadmill is not switched on
Switch on
e) Burnt fuse
Change fuse
Belt does not run properly
a) Belt requires lubrication
Lubricate the belt with silicone
b) Running belt too tight or loose
Adjust belt
Belt is slipping
a) Running belt is too loose
b) Motor belt is too loose
Adjust belt
Treadmill suddenly stops
a) The safety key dropped off the
control panel
Replace the safety key
Control panel buttons don´t work
a) Damaged control panel
Change the control panel
b) Cable disconnected or damaged
Change the cable
Information from monitor to controller
and feedback controller to monitor fail.
Check the cable that connects the
monitor to controller see if is lost or
injured
The voltage is above normal, the
motor or the controller are defective.
Check if the motor is damaged.
Make sure no objects obstructing
the normal movement of the belt or
the rolls, if no problems
up the controller must be replaced
Monitor receives no signal from the
safety key
Check the safety key connection.
Check the switch on the monitor if it is
in the correct position.
