Status
Status label
Icon(s) associated with status
Unknown
Unknown
Non-Replicating
Information needed
Pending synchronization
OK
Warning
Critical
Appliance throughput reports
NOTE:
The time zone of the report is shown on the upper right of the screen.
When the Appliance/Virtual Device is in the UTC time zone, the custom time period selection will use the
browser time zone from where you are accessing Reporting Central.
To obtain an appliance throughput report:
Procedure
1.
On the
Reports
page, select
Appliance
.
2.
In the
Groups
menu, you will see all available appliance groups that have been registered for
reporting. Select
All Appliances
, or select an appliance group.
3.
In the
Appliance
menu, select the specific appliance you want to run a report for.
4.
Select the devices you want to include in the report. The default (if you make no selection) includes all
devices. To select up to five specific devices, click
Select Device
, select the devices you want to
include, and click
OK
.
The resulting graphs show data points for the selected time period, with time and date stamps on the x
axis, and throughput on the y axis. The upper graph shows throughput for the selected devices. The
lower graph shows the throughput for replication sources or targets (VTL or NAS devices) or inbound
and outbound copy jobs (StoreOnce Catalyst). To the right of each graph, the selected devices and
device names will be shown. The lower graph will also show labels for source, target, inbound, or
outbound copy job information.
You can export the graphs; see
Exporting Reporting Central reports
on page 147 for details.
Stream count reports
The Stream Count report allows you to view data about the active streams running on your system. You
can select a specific device to view stream count data for, or if you do not select a device, the report will
show data for all device stream counts by default.
Procedure
1.
In the
Navigator
, select
Reporting Central
, and then select
Reports
.
2.
Select the
Stream Count
tab. The
Group
menu will default to
All Appliances
(you do not need to
change this).
Appliance throughput reports
151