HPE R/T3000 G2, User Manual

Page: 42 / 79

UPS operations 42
Button Assertion
time
Audible alarm Mode before
assertion
Utility
present ?
Action
On
0.5 seconds Every 0.5
seconds until the
button is released
Standby Yes Energizes the load and
resets the bypass entry
count to 0
Operate Yes Resets the bypass entry
count to 0
Auto-Bypass Yes Clears the UPS On audible
alarms, resets the bypass
entry count to 0, and
attempts to transfer to
Operate mode
Converter Off Yes Clears the UPS On audible
alarms, resets the bypass
entry count to 0, and
attempts to transfer to
Operate mode
Off
3 seconds Every 0.5
seconds until the
button is released
Operate Yes Transfers to Standby mode,
and power to the load
ceases
Standby Yes No action
Battery No Powers down the UPS, and
power to the load ceases
Auto-bypass Yes or No Transfers to Standby mode
or Converter Off mode, and
power to the load ceases
Self Test
0.5 seconds Any Yes or No Silences audible alarms
after 0.5 seconds
3 seconds Continuously Any Yes or No Initiates a self-test
Battery
Start
0.5 seconds Any Yes or No No action
Battery
Start and
On
3 seconds Continuously UPS off No Transfers to battery power,
and begins powering the
load
On and Self
Test
3 seconds Continuously Any Yes or No Enters or exits
Configuration mode
Configuring the UPS
The UPS automatically detects the number of ERMs connected.
In Configure mode, the LED front panel display changes function to enable modification of the UPS
parameters. Each LED is associated with a different parameter.
Available settings Parameter Associated LED Explanation (when LED is
illuminated)
Nominal voltage
setting
100/204 Nom Self Test Nominal output voltage is 100 V for a low
voltage model and 204 V for a high voltage
model
110/220 Nom Battery Fault Nominal output voltage is 110 V for a low
voltage model and 220 V for a high voltage
model
120/230 Nom Site Wiring Fault Nominal output voltage is 120 V for a low
voltage model and 230 V for a high voltage
model