6.
Slide the chassis into the rack.
7.
Allow the iLO CM firmware to discover the replacement cartridge. The cartridge link LED flashes when
this process is complete.
8.
Assign the original serial number to the replacement cartridge using the following command:
SET
CARTRIDGE SN <original SN> C<cartridge number>
9.
Assign the original product ID number to the replacement cartridge using the following command:
SET
CARTRIDGE PID <original PID> C<cartridge number>
Removing and replacing a cartridge blank
CAUTION:
For proper cooling, be sure that a cartridge or a cartridge blank is always installed in each cartridge
slot in the chassis. When replacing a cartridge, leave the cartridge slot empty for no more than 30
seconds. Failure to do so can disrupt airflow in the chassis.
Procedure
1. Extend the chassis from the rack
on page 11.
3.
Remove the cartridge blank from the chassis.
To replace the component, reverse the removal procedure.
Removing and replacing a cartridge blank
47
