HPE ProLiant DL325 Gen10 Plus, User Manual

Page: 95 / 149

20. Connect each power cord to the power source.
21. Power up the server.
22. If removed, install the bezel.
The installation is complete.
Installing the ODD in SFF
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1.
If installed,
remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Remove the inner rack rails.
7. Remove the access panel.
8. Remove the media bay blank.
9.
Remove the ODD cage blank.
10. Install the ODD into the cage.
Hardware options installation
95