52
[DeviceA] undo nqa schedule admin test1
# Display the most recent result of the HTTP operation.
[DeviceA] display nqa result admin test1
NQA entry (admin admin, tag test1) test results:
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 64/64/64
Square-Sum of round trip time: 4096
Last succeeded probe time: 2011-11-22 10:12:47.9
Extended results:
Packet loss ratio: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to internal error: 0
Failures due to other errors: 0
# Display the history records of the HTTP operation.
[DeviceA] display nqa history admin test1
NQA entry (admin admin, tag test1) history records:
Index Response Status Time
1 64 Succeeded 2011-11-22 10:12:47.9
The output shows that it took Device A 64 milliseconds to obtain data from the HTTP server.
UDP jitter operation configuration example
Network requirements
, configure a UDP jitter operation to test the jitter, delay, and round-trip time
between Device A and Device B.
Figure 13 Network diagram
Configuration procedure
1.
Assign IP addresses to interfaces, as shown in
. (Details not shown.)
2.
Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
3.
Configure Device B:
# Enable the NQA server.
<DeviceB> system-view
[DeviceB] nqa server enable
# Configure a listening service to listen on the IP address 10.2.2.2 and UDP port 9000.
[DeviceB] nqa server udp-echo 10.2.2.2 9000
4.
Configure Device A:
# Create a UDP jitter operation.
<DeviceA> system-view
IP network
NQA client
Device B
Device A
10.1.1.1/16
10.2.2.2/16
NQA server
Summary of Contents for FlexNetwork 10500 SERIES
Page 224: ...213 ...
Page 311: ...300 Now the system can record log information to the specified file ...