8/18/2020
HPE FlexFabric 5710 Switch Series - Installing the Switch
7/7
top
Grounding the switch by using a grounding strip
The power input end of the switch has a noise filter, whose central ground is directly connected to thechassis to form the chassis ground
(commonly known as PGND).Secure connect thischassis ground to the earth so the faradism and leakage electricity can be safely
released to theearth to minimize EMI susceptibility of the switch.
To ground the switch by using a grounding strip:
1. Attach the two-hole grounding lug at one end of the grounding cable to a grounding point on theswitch chassis.
2. Remove the hex nut of a grounding post on the grounding strip.
3. Attach the ring terminal at the other end of the grounding cable to the grounding post on thegrounding strip, and secure the ring
terminal to the grounding post with the hex nut.
Connecting the grounding cable to a grounding strip
top
Link to the list of available documents
Click here to view a list of documents available for the HPE FlexFabric 5710 Switch Series
.
top
©Copyright 2020 Hewlett Packard Enterprise Development LP
Hewlett Packard Enterprise Development shall not be liable for technical or editorial errors or omissions contained herein. The information
provided is provided "as is" without warranty of any kind. To the extent permitted by law, neither HPE nor its affiliates, subcontractors or
suppliers will be liable for incidental, special or consequential damages including downtime cost; lost profits; damages relating to the
procurement of substitute products or services; or damages for loss of data, or software restoration. The information in this document is subject
to change without notice. Hewlett Packard Enterprise Development and the names of Hewlett Packard Enterprise Development products
referenced herein are trademarks of Hewlett Packard Enterprise Development in the United States and other countries. Other product and
company names mentioned herein may be trademarks of their respective owners.
