Enabling client-to-client route reflection
Syntax:
[no] bgp client-to-client-reflection
Enables or disables client-to-client route reflection. When acting as a route-reflector, this functionality is enabled
by default.
Specifying cluster ID when BGP router is route-reflector
Syntax:
[no] bgp cluster-id
ip-address
Specifies the cluster ID to be used when the BGP router is used as a route-reflector. The cluster ID default is the
router ID.
BGP graceful restart
Table 36: Graceful restart commands
Command syntax
Description
Default
CLI reference
bgp graceful-
restart {restart-
time
val
|
[stalepath-time
val
]}
Configures BGP graceful
restart timers.
Configuring BGP
graceful restart timers
on page 363
[no] bgp log-
neighbor-changes
[prefix-list
prefix-list-name
]
Enables or disables BGP
event logging.
on page 364
[no] neighbor
ipv4-
addr
description
desc
Describes a neighbor.
on page 364
Configuring BGP graceful restart timers
Syntax:
bgp graceful-restart {restart-time
val
| [stalepath-time
val
]}
Configures BGP graceful restart timers as follows:
restart-time
The time in seconds to wait for a graceful restart capable neighbor to re-establish BGP peering.
stalepath-time
The time in seconds to hold stale routes for a restarting peer.
Chapter 17 Border Gateway Protocol (BGP)
363
