Auto-summary
Status of auto-summary for all interfaces running RIP. If auto-summary is enabled, subnets will be
summarized to a class network when advertising outside of the given network.
Default metric
Sets the default metric for imported routes. This is the metric that will be advertised with the imported route to
other RIP peers. A RIP metric is a measurement used to determine the "best" path to network: 1 is the best,
15 is the worst, 16 is unreachable.
Route changes
The number of times RIP has modified the routing switch’s routing table.
Queries
The number of RIP queries that have been received by the routing switch.
RIP interface information
RIP information on the VLAN interfaces on which RIP is enabled.
IP address
Address of the VLAN interface running RIP.
Status
Status of RIP on the VLAN interface.
Send mode
Format of the RIP updates: RIP 1, RIP 2, or RIP 2 version 1 compatible.
Recv mode
The switch can process RIP 1, RIP 2, or RIP 2 version 1 compatible update messages.
Metric
Path "cost," a measurement used to determine the "best" RIP route path: 1 is the best, 15 is the worst, 16
is unreachable.
Auth
RIP messages can be required to include an authentication key if enabled on the interface.
RIP peer information
RIP peers are neighboring routers from which the routing switch has received RIP updates:
IP address
IP address of the RIP neighbor.
Bad routes
Number of route entries which were not processed for any reason.
Last update timeticks
Number of seconds that have passed since we received an update from this neighbor.
Viewing RIP interface information
To display RIP interface information, enter the
show ip rip interface
command at any context level.
Syntax:
show ip rip interface [
ip-addr
| vlan
vlan-id
]
Chapter 8 Routing Information Protocol (RIP)
175
