MF877-00 Page 3
Template Revision A
HPE instructions for this template are available at
1. Using a Phillips screwdriver, remove the screw from the underside of the chassis holding down the main PCA
(screw is near the middle front of the underside of the chassis)
2. By hand, remove the four white hexagonal spacers near the heat sink
3. Using a small adjustable wrench, remove the three hexagonal studs near the heat sink that were under the
white hexagonal spacers (note: the fourth spacer was over a fastener that will not be removed
4. Using a Phillips screwdriver, remove the eight screws holding down the main PCA
5. Using a Phillips screwdriver, remove the three screws holding down the bridge PCA
6. Using a small adjustable wrench, remove the small hexagonal stud from the front left corner of the bridge PCA
7. Using a Phillips screwdriver, remove the two screws holding down the sheet metal air flow diverter
8. Remove the air flow diverter
9. Remove the main PCA from the chassis
10. Using a Phillips screwdriver, loosen the four heat sink screws and remove the heat sink
11. Remove the bridge PCA (connects the fan assembly PCA to the main PCA)
from the main PCA
1. Using a small adjustable wrench, remove the two nuts attaching the bridge PCA to the main PCA
2. Gently remove the bridge PCA from the main PCA while disconnecting the connector
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
