HPE AH395-9013J, User'S & Service Manual

Page: 39 / 204

To perform more advanced operations, press S to launch the UEFI Shell.
To view the iLO LAN configuration, press I to launch the iLO Setup Tool.
Saving UEFI configuration settings
You can configure other UEFI settings at this time. For more UEFI configuration options, see Utilities on
page 181.
Booting and installing the operating system
From the UEFI Front Page prompt, you can boot and install in either of two manners:
• If your OS is loaded onto your server, see Operating system is loaded onto the server .
• If the OS is not installed onto your server, see Operating system is not loaded onto the server .
Operating system is loaded onto the server
If the OS is loaded on your server, normally UEFI automatically boots to the OS. If the UEFI Front Page is
loaded, press
ENTER t to start auto boot, or B to select a specific boot option for your OS.
Use your standard OS login procedures, or see your OS documentation to log in to your OS.
Operating system is not loaded onto the server
There are three options on how to load the OS if it is not loaded onto your server.
• To load the OS from a DVD, see Installing the operating system from the DVD drive or tape drive
on page 43.
• To load the OS using Ignite-UX, see Installing the operating system using HP Ignite-UX on page
45.
• To load the OS using vMedia, see Installing the operating system with Virtual Media on page 45.
Saving UEFI configuration settings 39