HPA PM 6200, Owner'S Manual

Page: 6 / 20

4
PM6200
Front Panel Controls
Front Panel Controls
(1). EQ CONTROLS
These knobs provide
continuous control
of parametric EQ
for the Input Chan-
nels. Three bands of
equalization are pro-
vided: Low (80Hz),
±15dB,shelving type
Mid (2.5
kHz
), ±12
dB,
peak type,High (12
kHz
),
±15
dB
, shelving type
(2). MONITOR CON-
TROLS
These knobs provide
continuous control of
the level sent to the
Monitor bus. The
Monitor bus signal
is sent to the Monitor
Amp jacks in the In-
put/Output section.
AUX 1
MON
HF
12kHz
MF
2.5kHz
LF
80Hz
AUX 2
EFX
20dB
PAD
0 10
5
0 10
5
0 10
5
-15 +15
0
-12 +12
0
-15 +15
0
CHANNEL 1 C
VOLUME
0
0
0
-15
-12
-15
2
3
4
5
1
1. CHANNEL CONTROL SECTION
(6). EFX ON SWITCH
The EFX On switch
is used to turn the
internal Digital Effect
on and off. The effects
are by-passed whe
the switch depressed
and the display
shows two.
(7). DSP PROGRAM
SELECT SWITCH
The program knob
selects one of the 100
built-in digital effects,
for each number you
select. 24 Bit Digital
Effects processor with
high quality, studio
grade effects like
Delay, Chorus and
Reverb.
2. 24BIT DIGITAL EFFECT SECTION
(9). AUX IN CONTROL
This knob provides con-
tinuous control of the
level of signal sent from
the Aux In jacks to the
Main bus.
(10). TAPE IN CONTROL
This knob provides
continuous control of the
level of signal sent from
the Tape In jacks to the
Main bus.
(11). TAPE TO MONI-
TOR SWITCH
When this switch is on,
the signal of TAPE IN will
be sent to the MONITOR
bus.
ON
OFF
PROGRAM
EFX LEVEL
0 10
5
SELECT
EFFECTS
PERFORMANCE
HALL REVERB
PLATE REVERB
SPRING REVERB
ECHO
VERB
VERB
ECHO+VERB
CHORUS
FLANGE
6
7
L
8
If the Power Amp Select Switch (20) is set to the
MAIN+MONITOR position, the signal is also sent to
the Power Amp 2 jacks. The Monitor bus signal is
pre-level volume, and is unaffected by the chan-
nel’s Level Control (4).
(3). EFFECTS CONTROLS
These knobs provide continuous control of the level
sent to the Effects bus.
The Effects bus signal is sent to the internal DSP,
and to the EFX Output.
The Effects output signal is post-level volume, and is
directly affected by the channel’s Level Control (4).
(4). LEVEL CONTROLS
These knobs provide continuous control of the associ-
ated channel’s output signal level.
(5). PAD SWITCHES
These switches attenuate the input signal by –20dB.
Activate this switch when connecting a line-level
source to the associated channel, or when the input
signal is distorted.
3. AUX IN AND TAPE IN SECTION
0 10
5
LEVEL
9
10
11
0 10
5
ON
OFF
VOLUME TAPE TO
MONITOR
IN OUT IN OUT
(8). EFX LEVEL CONTROL
The EFX LEVEL control used to send the effect mix
bus to an external effect device connected to the
AUX2 SEND jack.