HP Workstation x4000, Technical Reference Manual

Page: 52 / 238

System BIOS and Resources
HP Setup Program
Chapter 4 52
Advanced Menu
Table 4-2 describes the submenus available in the Setup program
Advanced menu.
Table 4-2 Advanced Menu
Field Description
Processors Displays the type and the speed of the processor(s)
you have in your Workstation. You can change your
processor speed in the
Processor Speed
field by
selecting a value from the drop down menu. Your
processor cannot run any faster than what is
displayed in the
Current Type
field. If you leave
Processor Speed set to the default of
Auto
, the
processor speed is automatically detected. Use a
fixed frequency for troubleshooting only.
Chipset Memory Error Checking: You can choose between
ECC
and
Disabled
. ECC scrubbing checks for and
corrects errors at the source to prevent them from
reoccurring. Change this field to
Disabled
if you want
to find errors, but don’t want them corrected.
ECC Error Type: When an ECC error occurs, it
generates an interrupt. In this field, you can select
the type of interrupt you want reported:
NMI
(Non-Maskable),
SMI
(System Management),
SCI
,
(System Control), or
None
.
SERR signal condition: In this field, you can select
the type of ECC error condition that triggers a
critical system error (SERR#). Normally, only
Multiple
bit
(unrecoverable) errors should be able to trigger
SERR#. But you can also choose
Single bit
,
None
, or
Both
.
Floppy Disk
Drive Contains the floppy disk drive type and controller
fields. If you choose to disable your floppy disk drive,
you must also disable your floppy disk controller.
IDE Devices Lets you configure the settings for the IDE controller
and any attached IDE devices.
This manual downloaded from http://www.manualowl.com