HP WL520, User Manual

Page: 118 / 142

Parameter Tables
6-35
tcp/udp port filtering tcp/udp port filtering tcp/udp port filtering tcp/udp port filtering
The following parameters are used to enable/disable the Port filter feature.
The following parameters are used to configure TCP/UDP Port filters.
syslog parameters
syslog parameters syslog parameters
syslog parameters
The following parameters configure the Syslog settings.
NOTE:
The Heartbeat parameters are advanced settings not available via the HTTP interface. When Heartbeat is enabled,
the WL520 periodically sends a message to the Syslog server to indicate that it is active. The frequency with which the
heartbeat message is sent depends upon the setting of the Heartbeat Interval.
name
name name
name type
type type
type values
values values
values access
access access
access cli
cli cli
cli
Port Filtering Group N/A R portflt
Port Filter Status Integer enable (default)
disable RW portfltstatus
name name name name type type type type values values values values access access access access cli cli cli cli
Port Filtering Table Table N/A R portflttbl
Table Index N/A User Defined
(there are also 4 pre-defined
indices, see “
Port Number
”
below for more information)
R index
Port Type Octet String TCP
UDP
TCP/UDP
RW porttype
Port Number Octet String User Defined
(there are also 4 pre-defined
protocols:
NetBios Name Service – 137,
NetBios Datagram Service –
138, NetBios Session Service
– 139, SNMP Service – 161)
RW portnum
Protocol Name DisplayString User Defined
(there are also 4 pre-defined
protocols, see ”
Port
Number
” above)
RW protoname
Interface Bitmask Integer32 1 (Ethernet only)
4 (Slot A only)
5 (Slot A & Ether)
8 (Slot B only)
9 (Slot B & Ether)
12 (Slot A & B)
15 (All interfaces)
RW ifbitmask
Status Integer enable (1)
disable (2)
delete (3)
RW status
name name name name type type type type values values values values access access access access cli cli cli cli
Syslog Group N/A R syslog
Syslog Status Integer enable
disable (default)
RW syslogstatus
Syslog Port Octet String 514 R syslogport
Syslog Lowest Priority Logged Integer 1 – 7
1 = LOG_ALERT
2 = LOG_CRIT
3 = LOG_ERR
4 = LOG_WARNING
5 = LOG_NOTICE
6 = LOG_INFO (default)
7 = LOG_DEBUG
RW syslogpritolog
Heartbeat Status Integer enable (1)
disable (2) (default) RW heartbeatstatus
Heartbeat Interval (seconds) Integer 1 – 604800 seconds;
900 sec. (default)
RW heartbeatinterval