Installation Overview
1.
Review Important Guidelines
When replacing a failed drive, refer to
the documentation included with the server or disk enclosure system to
identify and remove a failed drive. See Important Guidelines for
Replacing Hot-Pluggable Hard Drives included on this poster.
2.
Remove failed drive
Follow the steps shown on this card.
3.
Install hot-pluggable hard drive
Follow steps shown on this card.
4.
Hard drive handling precautions
Hard drives are sensitive
electromechanical devices that can be permanently damaged through
improper handling. The packaging provided with a hard drive is
designed to protect it from accidental drops. HP recommends that hard
drives remain in their original packaging until installation. Drives
should be handled with care and never dropped, even from short
distances.
5.
Configuration
If this is an upgrade or new installation on a ProLiant-
based system, run the HP System Configuration Utility found on the HP
SmartStart CD.
CAUTION: Electrostatic discharge can damage electronic components. Be sure you
are properly grounded before beginning this procedure. Refer to the documentation
that came with your computer or contact your HP authorized reseller for procedures
to discharge static electricity.
Installing the Hard Drive
Follow these steps to install a hot-pluggable hard drive into a system. If you
are removing the blank drive bezel, perform step 1.
If you are removing a failed drive, perform step 2.
1.
Remove the blank drive bezel from the disk enclosure before installing
a new hard drive.
a. Press the ejector buttons simultaneously (1).
b. Pull the blank drive bezel from the disk enclosure (2).
2.
Remove the failed hard drive from the disk enclosure before installing
a new hard drive.
a. Press ejector button and pivot the lever to full open position (1).
b. Pull the drive from the disk enclosure (2)
3.
Prepare the replacement drive for insertion into the disk enclosure.
a. Press the ejector button of the hard drive (1).
b. Pivot the lever into the full open position(2).
4.
Insert the replacement drive into the disk enclosure.
a. Slide the replacement drive into the disk enclosure (1).
b. The ejector lever must be in the full open position while installing
the drive to ensure a correct latch (2).
5.
When the drive has been fully inserted, close the ejector lever. The
locking hinge must be engaged behind the fromt panel of the unit.
Drive Height Converter Option
To install a 1-inch hard drive into a 1.6-inch drive bay, attach a driveheight
converter to the drive assembly. The drive height converter option is sold
separately. Contact an HP authorized reseller for purchasing information.
Installation Instructions
Snap the drive height converter accessory into place, as shown in the
following figure. Proceed with the normal installation procedures.
To confirm a correct attachment, the front view of the drive should be level
on both the right and left sides and the fit should be snug.
CAUTION:
Do not carry the drive by the drive height converter. If the attachment is
not secure, the drive may fall, resulting in damage to the drive. This will void any
drive warranty.
2
1
1
1
2
2
1
1
2
