If you install a USB mouse and a USB keyboard in the secure USB compartment, route the cables
around and through the clips, then out the secure cable routing slot, as shown in the following
illustration.
Figure 2-7
Using the secure cable routing slot
Removing and Replacing the Battery
Before beginning the replacement process, review
General Hardware Installation Sequence
on page 10
for procedures you should follow before and after installing or replacing hardware.
WARNING!
Before removing the side access panel, ensure that the thin client is turned off and the
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1.
Locate the battery on the system board.
16
Chapter 2 Hardware Changes
