HP StorageWorks MSL2024, User'S And Service Manual

Page: 234 / 276

Recording configuration settings
If the OCP or RMI works, save the configuration settings to the USB flash drive from the OCP or to a
file from the RMI. You will need these settings to re-configure the Library after replacing the chassis.
TIP:
For the MSL4048, the configuration settings are saved on the library controller card and
should
transfer to the new chassis when you install the library controller card in the new chassis. Recording
the configuration settings is a good idea in case the library controller card has a problem or is
damaged during the transfer to the new chassis.
Removing the tape cartridge from the tape drive
Before beginning, be sure no cartridges are in the tape drives. To move a cartridge with the MSL2024
OCP, see “
Moving tapes in the Library (Operations > Move Tape) ” on page 123. To move a cartridge
with the MSL4048 OCP, see “ Moving Media (Operations > Move Media) ” on page 138. To move a
cartridge with the RMI, see “ Moving media ” on page 98.
CAUTION:
If you cannot remove the tape cartridge from the tape drive, handle the tape drive gently during the
rest of the procedure to avoid damaging the tape and losing data.
Removing the cables, magazines, and tape drives
If the OCP or RMI are operational, remove the magazines using the RMI or OCP.
Power off the Library. Remove the power cord and other cables from the Library.
If the magazines have not been removed, remove the magazines from the device using the manual
process (see “
Releasing the magazines manually ” on page 176).
To remove the tape drives:
1. Loosen the blue captive thumbscrews on the drive (see Figure 124 ).
Figure 124 Captive screws on the tape drive
.
Upgrading and servicing the Tape Library 234