10641
Figure 46 Setup screen
The Setup screen displays the following information:
• Change Network Settings
• Change Password
• Restore Factory Settings
• Drive Autoclean
• Drive Autounload
• Barcode Length
• Con
fi
gured Drives
• Both Load Ports
• Left Load Port (##)
• Right Load Port (##)
Load port slot numbers will be different for each drive technology (Ultrium is
18 and 36, and SDLT is 16 and 32).
6.
To edit the setup information, use the Up and Down arrows to highlight the section
and press Select.
• To view or change network settings, highlight
Network Settings
and press
Select
.
• To set the IP address, subnet mask, and gateway, use the Up and Down
buttons to select the appropriate number and press
Select
to accept.
• To enable/disable DHCP, use the Up and Down buttons to toggle
between enable/disable. Press
Select
to accept the setting. If your
library is not connected to a network that uses a DHCP server to assign
IP information, disable this function.
HP StorageWorks ESL E-Series Tape Library unpacking and installation guide
75
Summary of Contents for StorageWorks ESL E Series
Page 8: ...8 ...
Page 72: ...72 Loading tape cartridges ...
