8
Hewlett-Packard VPN Server Appliance SA3150 Regulatory Information
Installing a PCI Add-in Card
The vertically mounted riser card accommodates one
standard (left side) and one low-profile (right side) PCI
add-in card.
The following procedures describe how to install the add-
in card(s) in the server board:
•
Removing the Cover
•
Removing the Riser Card
•
Removing the Rear I/O Filler Panel(s)
•
Installing the Riser/Add-in Card(s)
•
Closing the Cover
Note:
Set the add-in card jumpers or switches according
to the manufacturer’s instructions.
Removing the Cover
1.
Loosen and remove the release screw located on the
top panel of the HP VPN Server Appliance SA3150
chassis.
2.
Slide the top cover back and lift to remove it.
Removing the Riser Card
Perform the following steps to remove the riser card from
the server board.
1.
Grasp the riser card at each end and gently rock and
lift the riser card until it is loose from the server board
connector.
2.
Remove the riser card from the server board
connector.
Summary of Contents for SA3150
Page 2: ......
