Removal and replacement procedures 39
Hot-plug power input module
To remove the component:
1.
If only one power input module is installed:
a.
Do the following:
—
For tower models, open and remove the tower bezel (on page
—
For rack models, if installed, remove the security bezel ("
b.
Power down the server (on page
2.
Release the power cords from the strain relief straps.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Remove the power supply.
Summary of Contents for ProLiant ML350 Gen9
