HP ProLiant DL60 Gen9, User Manual

Page: 78 / 127

Hardware options installation 78
8.
Install the TPM security rivet by pressing the rivet firmly into the system board.
9.
Install the PCI riser cage (on page 23 ).
10.
Install the access panel (on page 19 ).
11.
Install the server into the rack.
12.
Power up the server (on page 15 ).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker setup, and can be saved and printed after
BitLocker is enabled. When using BitLocker, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker detects a possible compromise of
system integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
•
Always store the recovery key/password in multiple locations.
•
Always store copies of the recovery key/password away from the server.
•
Do not save the recovery key/password on the encrypted hard drive.
Enabling the Trusted Platform Module
1.
During the server startup sequence, press the
F9
key to access System Utilities.
2.
From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Server Security .
3.
Select Trusted Platform Module Options and press the Enter key .
4.
Select
Enabled
to enable the TPM and BIOS secure startup. The TPM is fully functional in this
mode.
5.
Press the F10 key to save your selection.
6.
When prompted to save the change in System Utilities, press the Y key.
7.
Press the
ESC
key to exit System Utilities. Then, press the
Enter
key when prompted to reboot the
server.
The server then reboots a second time without user input. During this reboot, the TPM setting becomes
effective.