HP ProLiant DL60 Gen9, User Manual

Page: 18 / 127

Operations 18
Remove the server from the rack
WARNING: This server is very heavy. To reduce the risk of personal injury or damage to the
equipment:
• Observe local occupational health and safety requirements and guidelines for manual
material handling.
• Get help to lift and stabilize the product during installation or removal, especially when the
product is not fastened to the rails. Hewlett Packard Enterprise recommends that a
minimum of two people are required for all rack server installations. A third person may be
required to help align the server if the server is installed higher than chest level.
• Use caution when installing the server in or removing the server from the rack; it is unstable
when not fastened to the rails.
To remove the server from a Hewlett Packard Enterprise, Compaq-branded, Telco, or a third-party rack:
1.
Power down the server (on page 15 ).
2.
Disconnect all peripheral cables from the server.
3.
Disconnect each power cord from the server.
4.
Extend the server on the rack rails until the server rail-release latches engage.
5.
Remove the server from the rack.
For instructions on how to extend or remove the server from the rack, see the documentation that
ships with the rack rail system.
6.
Place the server on a sturdy, level surface.
Remove the security bezel (optional)
The security bezel is only supported in servers using the quick-release latch rack ears.
To access the front panel components, unlock and then remove the security bezel.
Remove the access panel
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.