HP ProLiant DL380 Gen9, User Manual

Page: 32 / 215

Operations 32
6.
Install the access panel (on page 28 ).
7.
Install the server into the rack (" Installing the server into the rack " on page 39 ).
8.
Connect each power cord to the server.
9.
Connect each power cord to the power source.
10.
Power up the server (" Powering up the server " on page 26 ).
Secure the full-length expansion board retainer
1.
Power down the server (on page 26 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Extend the server from the rack (on page 26 ).
4.
Remove the access panel (on page 27 ).
5.
Install a full-length expansion board (" Installing an expansion board " on page 118 ).
6.
Install the PCI riser cage (on page 31 ).
7.
Secure the full-length expansion board retainer.
8.
Install the access panel (on page 28 ).
9.
Install the server into the rack (" Installing the server into the rack " on page 39 ).
10.
Connect each power cord to the server.
11.
Connect each power cord to the power source.
12.
Power up the server (" Powering up the server " on page 26 ).
Remove the air baffle
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components,
minimize the amount of time the access panel is open.
To remove the component:
1.
Power down the server (on page 26 ).