Removal and Replacement Procedures
HP ProLiant DL320 Generation 3 Server Maintenance and Service Guide
2-13
3.
Remove the four screws that secure the hard drive to the hard drive tray (1).
4.
Remove the hard drive from the hard drive tray (2).
Figure 2-8: Removing the SATA hard drive from a hard drive tray
To replace the SATA hard drive, reverse steps 1 through 4.
IMPORTANT:
While replacing the drive, make sure that the LED light pipes of the tray are seated
properly in their slots.
SCSI Hard Drives
To remove a hard drive from the hard drive bay:
1.
Power down the server. See “Powering Down the Server” in this chapter.
2.
Remove the access panel. See “Access Panel” in this chapter.
3.
Disconnect the SCSI cables from the hard drives.
4.
Disconnect the power cables from the hard drives.
5.
Loosen the thumbscrew that secures the hard drive tray to the chassis (1).
6.
Slide the tray toward the front of the server and lift the tray out of the chassis (2).
