NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for additional information.
NOTE: HP does not allow factory integration of options into standard models listed above. Configure-to-order servers must start with a
CTO Chassis.
NOTE: FIO indicates that this option is a Factory Installable Option.
Step 1: Base Configuration (choose one of the following configurable models)
Non-Hot Plug SATA Model
NOTE: Non-Hot Plug models are not upgradeable to Hot Plug.
NOTE: The addition of a Smart Array controller is supported for external storage use
only.
HP ProLiant DL160 G6 Non-Hot Plug SATA Rack CTO Chassis
491531-B21
Factory Integrated Model ships with:
HP NC362i Integrated Dual Port Gigabit Server Adapter
One available full-length/full-height PCI-Express x16 Generation 2 slot
One Highline IEC Power Cord
6 Non-Hot Plug Fans
Rack (1U), (1.75 in / 4.45 cm)
Tool-less Fixed Rails
Hot Plug Model
HP ProLiant DL160 G6 Hot Plug SAS/SATA Rack CTO Chassis
491532-B21
Factory Integrated Model ships with:
HP NC362i Integrated Dual Port Gigabit Server Adapter
One available PCI-Express Generation 2 slot:
Slot 1: half-length/full-height
Slot 2: low-profile/half-height - occupied by HP Smart Array P410 Controller
One Highline IEC Power Cord
6 Non-Hot Plug Fans
Rack (1U), (1.75 in / 4.45 cm)
Tool-less Fixed Rails
QuickSpecs
HP ProLiant DL160 Generation 6
Configuration Information - Factory Integrated Models
DA - 13247 Worldwide QuickSpecs — Version 11 — 11.16.2009
Page 15
