Hardware options installation 35
17.
Connect the fans to the system board connector.
18.
Install the processor air baffle (on page
19.
Install the access panel (on page
20.
Slide the server into the rack.
21.
Connect each power cord to the server.
22.
Connect each power cord to the power source.
23.
24.
If removed, install the rack bezel (on page
Memory options
IMPORTANT:
This server does not support mixing RDIMMs or UDIMMs. Attempting to mix any
combination of these DIMMs can cause the server to halt during BIOS initialization.
The memory subsystem in this server can support RDIMMs or UDIMMs. The two types are referred to as
DIMMs when the information applies to the two types. When specified as RDIMM or UDIMM, the information
applies to that type only. All memory installed in the server must be the same type.
The server supports the following DIMM speeds:
•
Single-rank PC3-12800 (DDR-1600) DIMMs operating at 1600, 1333, and 1066 MHz
•
Single-rank and dual-rank PC3-10600 (DDR-1333) DIMMs operating at 1333 and 1066 MHz
For more information on the effect of DIMM slot population, see "General DIMM slot population guidelines
)."
HP SmartMemory
HP SmartMemory, introduced for Gen8 servers, authenticates and unlocks certain features available only on
HP Qualified memory and verifies whether installed memory has passed HP qualification and test processes.
Qualified memory is performance-tuned for HP ProLiant and BladeSystem servers and provides future
enhanced support through HP Active Health and manageability software.
